ISSN: 2717-7203
Comparative in C350 analysis of residual and surface stresses maraging steel processed by conventional and non-conventional manufacturing methods
1Tübitak Sage, Ankara, Türkiye
J. Adv. Manuf. Eng. 70-79 DOI: 10.14744/ytu.jame.2026.00007

Abstract

Residual stress significantly affects the fatigue life of critical aerospace components. This study presents a comparative analysis of the surface topography and residual stress profiles of 18Ni-350 maraging steel (C350) machined using conventional milling and Wire Electrical Discharge Machining (WEDM). Samples (10 mm × 10 mm × 10 mm) were machined under controlled parameters: a spindle speed of 45,000 RPM for milling, and a 0.6 mm diameter
wire with deionized water for WEDM. Stress responses and surface integrity were characterized using X-Ray Diffraction (XRD) and 3D surface profilometry. The results indicate that milling induces high compressive residual stresses (up to -400 MPa), which enhance fatigue resistance. In contrast, WEDM produces a mixed or tensile stress state (ranging from -139 MPa to +14 MPa) and significant XRD peak broadening (FWHM ≈ 5.4°–5.7°), indicative of thermal degradation, even though its surface roughness is in fact the lowest and most consistent among all conditions (Sa ≈ 3.7–4.9 µm); milling instead produces the highest and most variable roughness (Sa ≈ 4.9–15.9 µm, depending on surface and cutting trajectory). These findings highlight that, although WEDM offers geometric versatility, post-processing surface treatments are essential to mitigate tensile stresses and restore structural integrity.